Software : : AutoVisible.sbar: Have all your sbars visible on AutoScroll screens!
Posted By: igracki. on 2017/3/18 14:03:51
If you are using an AutoScroll screen (where the real width of the screen is greater than the visible width) and it annoyed you that not all sbar modules, especially the clock;) are visible if you are "working" on the left side of the screen, then you should my new screenbar module!

If the "left" side of such a screen is visible, then some of the screenbar modules aren't visible in the titlebar because they are adjusted to the right and therefore (partially) in the invisible area.

AutoVisible.sbar adds an extra empty space (depending on the position of the screen) to the titlebar, to have all your sbar modules in the visible area. Well, only if you are not having that many modules, that they don't fit into the visible area;)

NOTE:
After the first start, you should move this sbar module to the far right position!

INSTALLATION:
=============

Just copy the contents (its only the sbar module) of the "SYS" directory to your SYS: partition and select "Refresh" from the screen depth-gadget menu or reboot.


FUTURE:
=======

I think about adding a "border" for the mouse position, so that the screen will be moved not only if you reach the far left/right position of the screen, but earlier if the mouse is f.e. 200 pixels from the left/right.

You can download it here.
 
  • Order of the Butterfly
    Order of the Butterfly
    igracki
    Joined: 2003/2/24
    Posts: 416
    From: Berlin
    Quote:

    Thanks Thomas for this new tool for Ambient !

    Thank you, for your donation!
  • »2017/3/18 20:13
    Profile Visit Website
  • Order of the Butterfly
    Order of the Butterfly
    igracki
    Joined: 2003/2/24
    Posts: 416
    From: Berlin
    New version v1.1 released, you are now able to move the screen if you have the ctrl key pressed while you move the mouse!
    Dowload it from the same place or with Grunch
  • »2017/3/25 13:56
    Profile Visit Website