In past I read several times the MPC5200b Datasheet, Users Guide and Users manual, and nowhere mentioned only one device.
There is mentioned only:
- only one ATA controller
- ATA ver. 4 compatible.
Note: Two devices per controller supported from ATA v.1, two controllers from v.2, v.3 adds S.M.A.R.T, v.4 adds support for CD (ATAPI)
- low controller current
- short cable needed
- missing CSEL signal - i.e. pin 28 not connected.
It means we need:
- external power for IDE bus
- short ( I have 5 cm ) 44-pin ATA cable with three connectors M-F-F, crossed pairs between M and F
- setup disks (or IDE-SATA converters) with jumpers to master and slave.
All was tested with IDE HDD and IDE-mSATA converter + mSATA SSD. Prooved in Open firmware, link is in post #2 above.
AmigaOS3: Amiga 1200
AmigaOS4: Micro A1-C, AmigaOne XE, Pegasos II, Sam440ep, Sam440ep-flex, AmigaOneX1000
MorphOS: Efika 5200b, Pegasos I, Pegasos II, Powerbook G4, Mac Mini, iMac G5, Powermac G5 Quad