Hi

In the install doc's it says that you can install BOOT.IMG to a FFS partition
and the 2.2MorphOs system to another partion a SfS type

so to run MorphOs like this i would,

Boot hd:0(as this is my boot partition) boot.img(will this find the FFS partition)

or is there something else to the command, as it doesnt seen to boot for me..

(Efika)

Using a separate FFS partition for your boot.img is not really necessary unless you're using a Peg1, the OF boot command needs to know where the boot.img is located, so if "ls hd:0" in OF shows your boot.img, that command should work.

Now I don't know how your hdd is partitioned, so until you give a little more info there's not much else I can tell you.

For an efika a single SFS (or FFS if you prefer that) partition for boot.img and MorphOS is the prefered setup, also the installer expects that for update installs.

sorry got it booting

can you pls explain this a little more.
For an efika a single SFS (or FFS if you prefer that) partition for boot.img and MorphOS is the prefered setup, also the installer expects that for update installs.

ok i have 9 partitions
0. boot just over 4gb
1. morphos boot/root
2. morphOs Home/Data
3. Fat for data between morph n linux
4. Suse Root
5. Suse Home
6. Debain Root
7. Debin Home
8. Linux Swap

i was going to use boot for the loaders
i think the table expains its self...

how im i best installing MorphOs and what disk format?..where would boot.img go?..

I DON'T have it booting

loads to
Quark/openfirmware

then hangs

installed morphos to hd0:1 : using

boot dh1: boot.img : to run OS ,,,but it just hangs as i said above

file system FFS,, boot flag 0