Order of the Butterfly
Posts: 275 from 2015/6/30
This is the problem Jim. what you said about the Sam460ex is incorrect according to http://www.morphos-team.net/hardware .
Hardware Compatibility
On this page, you find a list of hardware that is directly supported by MorphOS 3.x.
Ethernet
On-board 10/100/1000MBit Ethernet on Sam460cr/ex (PPC460)
Quote:Jim wrote:
Quote:Spectre660 wrote:
Read the part of his first post that I quoted.
I quote it again .
Quote:
Jim wrote:
Quote:
Spectre660 wrote:
"Why cant I get my Sam460ex a network connection under MorphOS?"
Because you were too stupid to install a supported network card, until a native driver was created?
Since that is EXACTLY what X1000 owners had to do originally.
When you have a GOOD point, come back.
End of his quote :
Quote:redrumloa wrote:
Quote:
Spectre660 wrote:
Hah hah hah.
Truth revealed on his level of knowledge.
Now you have gone either full stupid or full troll.
Anyhow, how about being a man and give full disclosure for your purpose for promoting this board on Morphzone? What percentage of gross profits will you receive for your Linux porting and promotional efforts?
Sorry, you really have lost me.
You do realize a standard network card would have taken care of that issue, don't you?
And using expansion card to replace onboard devices that are not supported yet is an OS4 tradition.
I DO apologize for using the word 'stupid'.
That was uncalled for.
we have had perfectly civil interactions in the past.
