Hi,

I tried a D-Link DU-520 RevA2 in my Peg1/April2, but the peg doesn't want to boot anymore, if the card is plugged!?

The last lines I see in the serial debug log, are some "usb_ohci:" lines (see attached picture).

USB2-Boot.jpg

Anyone knows of incompatibilities with an USB2 card in a Peg1? Or is the card broken?

Bye!

Tried "setenv usb-enable? false" yet?

"Error: no such configuration variable!"

Seems my firmware doesn't support this envvar.

But I doubt this could help, because I can't even see any firmware output with the card installed;-(

That usb enable env var is only available with V1.2 of openfirmware.

I got that var in my peg2 after updating the open firmware, but I can't say if there is any update for the peg1.

Geit

hello,

i had the same problem with USB2 card with NEC chipset, it didn't boot with my peg1, but it did boot with my peg2, but didn't work... card with VIA chipset seams to work without any troubles (with Peg2)... with Peg1 I'll probably try tonight...

bye, MarK.