Hello,

i have bought this joystick for MorphOS 3.19 but the led is off when i connect the USB cable, i have a "? In activity" in state, "Vendor" as class and no attached class.

Any ideas please? Tested on G5

Same problem with another joystick normally compatible...

I have tried with and without hub with power supply.

Thanks for your help

You can try by deleting (after backup the file) the file poseidon.prefs in Sys:Prefs/env-archive/sys and reboot MorphOS.

Quote:

Thanks for your answer AKiLL, unfortunaly no changes...

I have started from MorphOS CD too... same result

Do a Class scan in USB settings. You likely do not have the xbox driver loaded.

@jacadcaps: i have this message: "Forced device binding of GameSir-G7 SE Controller for Xbox to xbox360.class failed"

i have xbox360.class 4.12 (2.2.2022) from 3.19

Gamesir recommended steps:
- re-connect the gamepad
- try a different cable
- press and hold home+m for 3s on the gamepad
- press and hold home+share for 3s on the gamepad

Thanks for the recommended steps

With a JSAUX cable and the recommended steps the LED is ON now but impossible to force device binding to xbox360 class after many try, even a restart of the USB stack.

[EDIT] A strange thing, after a reset of the USB stack , i must always do SHARE + m to have the LED ON.

[EDIT2] "Same problem with another joystick normally compatible..."
Now the other gamecontroller has xbox360 class and work fine... bizarre

Share-M might be forcing an incorrect mode for the xbox driver. Hard to say, I don't have this gamepad. Are you sure it has up-to-date firmware?

Quote:

Ok, thanks! i will update the firmware and retest.

I have udated the firmware from v6.38 to 6.40 but no change unfortunally...

[EDIT] SHARE + M seems do nothing (of visible)...

I’ll send you a debug version of the driver, but it may take me a couple of days.

Quote:

ok, nice, thanks a lot!!!