PowerMac G5 A1047 Video Out of Range
  • Just looking around
    Derek
    Posts: 3 from 2023/1/10
    Hi,

    I have a PowerMac A1047 fitted with a ATI Radeon 9600XT 128MB Graphics card.

    When I boot from MorphOS CD-ROM disk, the VGA monitor goes out of range and says display not supported.

    What is the video resolution of installation MorphOS?

    I have a MacMini G4 1.25Ghz, installed with MorphOS, which works at 640x480 on the same monitor.
    Regards,
    Derek
  • »08.03.24 - 10:33
    Profile
  • Order of the Butterfly
    Order of the Butterfly
    Zetec-s
    Posts: 192 from 2008/7/10
    From: Cheshire, UK
    If you press CTRL during booting up this should force MorphOS to use a resolution of 1025x786 which most displays can show.
    PowerMac G5 Quad 2.5Ghz/2GB MorphOS 3.18 Registered
    Powerbook 1.67Ghz/1.5GB MorphOS 3.18 Registered
    MacMini 1.5Ghz/1GB MorphOS 3.18 Registered
    Efika 5200B 400Mhz/128MB MorphOS 2.3 Registered
  • »08.03.24 - 23:13
    Profile
  • Yokemate of Keyboards
    Yokemate of Keyboards
    Andreas_Wolf
    Posts: 12073 from 2003/5/22
    From: Germany
    > 1025x786

    1024×768 ;-)
  • »08.03.24 - 23:28
    Profile
  • Just looking around
    Derek
    Posts: 3 from 2023/1/10
    Hi,

    Thank you for the information, I tried pressing the CTRL key on MorphOS boot up and it the video changed from 1024x768@75 to 1024x768@60

    I have installed MorphOS to the 160Gb Hard drive, and all is working, was able to connect to my Network Shares on a Linux server.

    I will have re-read the re-read the documentation again.

    [ Edited by Derek 09.03.2024 - 19:05 ]
    Regards,
    Derek
  • »09.03.24 - 11:37
    Profile