Sam460ex - Ethernet (10 Mbit) link only
  • Caterpillar
    Caterpillar
    Posts: 33 from 2020/5/1
    So, the Sam460ex and my router/gateway support 1000 Mbit. But I only get a 10 Mbit link with MorphOS. Is this a known limitation of the driver?

    Edit: changed cable and router/gateway, still 10 Mbit link speed only.

    [ Edited by duga 06.05.2020 - 21:46 ]
  • »06.05.20 - 16:19
    Profile
  • Caterpillar
    Caterpillar
    Posts: 33 from 2020/5/1
    Actually, I haven't yet checked speed/duplex at the other end. It might be that it's only _reported_ as 10 Mbit.

    Is it possible to change speed/duplex and autoneg on/off?
  • »07.05.20 - 19:35
    Profile
  • Caterpillar
    Caterpillar
    Posts: 33 from 2020/5/1
    I can confirm it's linked in 1000 Mbit, but reported as 10 Mbit.

    I might try to read the actual value (in bits) reported by the eth chipset, via SANA.
  • »08.05.20 - 12:16
    Profile
  • MorphOS Developer
    jacadcaps
    Posts: 2159 from 2003/3/5
    From: Canada
    Confirmed to be a reporting issue.
  • »08.05.20 - 12:34
    Profile Visit Website
  • Caterpillar
    Caterpillar
    Posts: 33 from 2020/5/1
    Quote:

    jacadcaps wrote:
    Confirmed to be a reporting issue.


    Reporting, or reported? I'm reading this as something that has been reported before and is a known bug. Correct me if I'm wrong.
  • »08.05.20 - 12:41
    Profile
  • MorphOS Developer
    Piru
    Posts: 445 from 2003/2/24
    From: finland, the l...
    The driver merely reports the speed wrong.
  • »08.05.20 - 13:15
    Profile
  • Caterpillar
    Caterpillar
    Posts: 33 from 2020/5/1
    Quote:

    Piru wrote:
    The driver merely reports the speed wrong.


    Ah, now I get it. Thanks.
  • »08.05.20 - 13:17
    Profile
  • Caterpillar
    Caterpillar
    Posts: 33 from 2020/5/1
    How can one help fixing/updating the Sam460 eth driver so that it can report 100 and 1000 Mbit link?
  • »07.10.20 - 19:32
    Profile
  • MorphOS Developer
    cyfm
    Posts: 409 from 2003/4/11
    From: Germany
    Quote:

    duga schrieb:
    How can one help fixing/updating the Sam460 eth driver so that it can report 100 and 1000 Mbit link?


    Well, it's on our bugtracker, it will possibly be targeted for 3.15, it didn't make it into 3.14, unfortunately.
  • »09.10.20 - 08:31
    Profile Visit Website
  • Caterpillar
    Caterpillar
    Posts: 33 from 2020/5/1
    Is it possible to "sign up" as beta tester/developer for a single driver? With access to only the source code needed for the driver, nothing else.
  • »09.10.20 - 10:34
    Profile