msata+msata to 2,5 IDE on Powerbook G4
  • Order of the Butterfly
    Order of the Butterfly
    kickstart
    Posts: 215 from 2009/4/28
    From: Land of Santa
    Hi!

    Im trying to instal a 32gb msata disk with a msata to ide adaptor, Morphos dont recognize the disk, anyone have another of this msata disks on a Powerbook G4?... I need to prepare msata for first use?

    Thanks.
  • »09.10.18 - 19:54
    Profile
  • Order of the Butterfly
    Order of the Butterfly
    Templario
    Posts: 256 from 2012/4/28
    Do you know if the Power Book recognizes this drive?
    Because this is the problem in macs when you change the hard diks.
    Amiga 500 with ROMs 1.3-2.05 and M-Tec AT 500 with hard disk and 4MB Ram.
    WinUAE + original OS 3.5&3.9
    Sam440ep 800 MHZ + OS 4.1 F.E.
    Sam460ex 1 GHz + OS 4.1 F.E.
    MacMini 1.5 GHz + MorphOS 3.11
    PowerBook G4 1.65 + MorphOS 3.11
  • »09.10.18 - 20:10
    Profile Visit Website
  • Order of the Butterfly
    Order of the Butterfly
    kickstart
    Posts: 215 from 2009/4/28
    From: Land of Santa
    OSX Leopard install disk boot but installation dont start, a grey prohibition signal image appears.
  • »09.10.18 - 20:56
    Profile
  • Order of the Butterfly
    Order of the Butterfly
    Templario
    Posts: 256 from 2012/4/28
    Uff, I think that you have the problem the mac controller drives doesn't work.
    Amiga 500 with ROMs 1.3-2.05 and M-Tec AT 500 with hard disk and 4MB Ram.
    WinUAE + original OS 3.5&3.9
    Sam440ep 800 MHZ + OS 4.1 F.E.
    Sam460ex 1 GHz + OS 4.1 F.E.
    MacMini 1.5 GHz + MorphOS 3.11
    PowerBook G4 1.65 + MorphOS 3.11
  • »09.10.18 - 21:30
    Profile Visit Website
  • Order of the Butterfly
    Order of the Butterfly
    kickstart
    Posts: 215 from 2009/4/28
    From: Land of Santa
    Controller problem? IDE hard disks runs fine.
  • »09.10.18 - 21:56
    Profile
  • MorphOS Developer
    geit
    Posts: 918 from 2004/9/23
    Die Problem is probably related to Master/Slave. Usually thats done by Firmware of 2.5" drives as there are no jumpers.

    If I recall right, we had the same issue on a geit@home meeting and the solution was to put the SSD to the CDROM port.

    Probably polluks knows as it was his powerbook.

    And just to be clear. There is not special init required when it fails, something is not compatible.

    [ Edited by geit 10.10.2018 - 01:44 ]
  • »09.10.18 - 23:43
    Profile
  • Order of the Butterfly
    Order of the Butterfly
    kickstart
    Posts: 215 from 2009/4/28
    From: Land of Santa
    Then back to the original 2,5 IDE hard disk... thank you for all the answers.
  • »10.10.18 - 16:55
    Profile