My Peg only appears to be connecting to my router at 10MB/s whether I use the onboard VIA junk or an rtl8139 card.

I've looked around all the config files in the db directory but nothing obvious there.

Does anyone know how to set the LAN speed to 100MB/s using MOSNet?

It's 100Mbit/s not MB. So you will get 3-8MB/s, thats what i get when i push some date to my PC or from PC to the Peg.

look in env:sana2/ dir

there should be a rtl_8139pci_0.config and options are
10BASET/S,100BASETX/S,FULLDUPLEX/S

for via_rhinepci_0.config you can set
10BASET/S,100BASETX/S,FULLDUPLEX/S,AUTONEGOTIATE/S

edit these

Quote:

I don't have such a dir on my machine.

A search for #?.config#? shows general.config in the mosnet/db dir and a couple of unrelated things in the SDK dir.

Quote:

Yes, typo on my behalf.

The MOSNet GUI shows "Speed: 10M", whereas it should say "Speed 100M" as both my router and ethernet support 100Mb/s.

*bump*

Any ideas gents?

I have not tested speeds, but atleast my router reports that Peg2 is connected at 100M on HW level eventhoug Mosnet GUI says 10M.

Your connection is already running at 100MBit.
MOSNet is only reporting a wrong value.
You can disable it in the preferences.

[ Edited by Wishmaster on 2007/3/24 10:48 ]

Get AmiTradeCenter and move some Files in your Network, then you can see how fast or slow the connection is.

Here MOSNet reports 100M.

>Get AmiTradeCenter and move some Files in your Network, then you can see how fast or slow the connection is.

To a PC that has a 10M only network interface... Over powerline-ethernet bridge that supports upto about 10Mbit/s.... yep..... :)