Quote:

How do you create these? Since there isn't a "RAWBInfo" type utility on MOS, I'm not sure how this is done -- or are they like AROS icons (where two PNG icons are joined together)?

Thanks.

It was very late last night when I posted this -- forgot some things . . .

First of all -- THANK YOU Itix for adding this!

It seems to work perfectly -- just can't figure out how to create icons.

If anyone else would like to try this, there are many, many 32bit glowicons at Mason's site.

Quote:

AFAIK there is no tool to create 32bit glowicons but it could be trivial to write one. Format is quite simple.

Quote:

Not at all. They are like old 8bit glowicons but there are two zlib compressed ARGB chunks.

@itix
Quote:

I suspect that 32bit Glow Icons gets me geeked up more than most people -- hopefully someone will create a tool at some point.

Thanks, again.

Hm, this new icons are not bad, but reading them takes much more time than the png-ones. :( (Reading a directory with 20-30 icons takes me 1-2 seconds...)

Quote:

Well, i always like the feature of two icons states.

Were did u get those icons from?

@ dIGIMAN
Well, i always like the feature of two icons states.

Me neither.
It's great to see that one of AmigaOS-only specific feature is saved in MOS for future.
Big thanks ITIX

Quote:

As mentioned below, there are a lot of them on Mason's home page (www.masonicons.de).


[ Edited by GK_LKA on 2007/1/15 14:56 ]

Try this: glow32. It is simple command line tool to create 32bit glowicons from two images. I dont intend to develop it further but with this tool you can experiment with your own drawings.

Quote:

Thank you (again!)

Edit: Just tried it -- works perfectly!

[ Edited by klesterjr on 2007/1/15 15:45 ]