• Just looking around
    Posts: 4 from 2020/10/15
    Quote:

    _coliN_ schrieb:
    Hello!

    After your post with your problems, I started a quick try to boot 3.14 on my Pegasos I.
    I dont know the exact firmware version, but I have 1 GB RAM, and use a Harddisk and a DVD on the first IDE, and a DVD-writer on the secondary IDE. I booted successful the new MorphOS 3.14 with this setup. Tomorrow I will install, and look forward to give Wayfarer a try...;)

    My command is every time the same, when I have to boot a update CD:

    Boot /pci/ide/cd@1,0 bootpeg1.img

    To say only /ide/cd as argument never worked for me in the past...

    Good luck!

    Bo



    Hi _coliN_:
    thanks for your reply.

    Finally I found a way to boot.
    Because the OFW always complaint about "no filesystem recognized" when I tried to

    boot /pci/ide/cd@...

    I did the following (glad to found an old MorphOS 3.8 installation in disk):
    I booted from disk, copied "bootpeg1.img" to disk, rebooted into OFW and

    boot /pci/ide/disk@0,1:0 bootpeg1.img !

    I did an upgrade and have a completed MorphOS 3.14 installation so far...

    But I have to say that OFW/Pegasos1-system is just a big piece of rubbish.
    I could "ls" the cd, but when trying to boot, it always complaint about "no filesystem recognized"...
  • »23.10.20 - 11:42
    Profile