Priest of the Order of the Butterfly
Posts: 545 from 2015/6/18
From: Funeralopolis
Thanks for the hint! But unfortunately it didn't turn out yet...
Quote:
rxcmd WLANMNGR_GLOBAL GET_IFACEPORT bcm43xx_wl.device:0
quits with an error message "RXCmd: wrong number of arguments".
So I got the connection data from LUbuntu Linux 14.04 running on the same Powerbook 5.4. The data is retrieved from the config file, after networkmanager successfully connected to the university network:
Code:
[ipv6]
method=auto
[connection]
id=eduroam
uuid=e07e6e45-9bd9-4ca7-b001-2e7bd71adb1c
type=802-11-wireless
[802-11-wireless]
ssid=eduroam
mode=infrastructure
mac-address=00:0D:93:83:7D:A3
security=802-11-wireless-security
[802-1x]
eap=peap;
identity=username
phase2-auth=mschapv2
password-flags=1
[ipv4]
method=auto
[802-11-wireless-security]
key-mgmt=wpa-eap
auth-alg=open
Which I use in ENVARC:Wireless.prefs like that:
Code:
network={
ssid="eduroam"
mode=infrastructure
eap=peap;
identity="username"
psk="password"
phase2-auth=mschapv2
password-flags=1
key-mgmt=wpa-eap
auth-alg=open
priority=1
}Is there any log-file written where I can check what went wrong during connection setup in MorphOS?
Talos II. [Gentoo Linux] | PMac G5 11,2. PMac G4 3,6. PBook G4 5,8. [MorphOS 3.18 / Gentoo Linux] | Vampire V4 SA [ApolloOS / Amiga OS 3.2.2]
