I need some help getting serial logs after the OS is fully booted up.
I read here that there is no need to do anything special to enable serial output because it is the built-in default debug output. But I got no output at all after the uboot prompts, so I used the commands bigfoot told me in one of my other threads:
Code:

With this, I receive serial output during booting of MOS. However after MOS is ready, no more output at all.

I also did some more runs with memtest EXTENSIVE and VMEM. No errors.
But SDK installation still fails every time resulting the OS to become gradually unusable.

Edit: Sometimes the SDK installation stops with "Installation failed: input data is illegal or corrupted".
Then I can close the Window and the system does not crash. Of course, I already redownloaded the file to exclude issues with the downloaded archive.

The problem seems to be caused by extensive file excess, as I also get these issues when using Wayfarer.

Any more suggestions for troubleshooting are appreciated.

[ Edited by Skygecko 04.09.2023 - 20:37 ]