Hi,

Is Barfly a dead product?
It seems that it's stuck to 2.00 and hunks format how about a new version specific to Morphos assembly development?
I know about Vasm, but AFAIK there's no debugger under Morphos Barfly one can be used to this end no?

Thanks
Kamle

Excuse me. Are you trying to build 68k apps under MorphOS or PPC native ones?

Hi, afaik, there is no conventional debugger under MorphOS at all. And i guess, even Barfly's one won't work. Iirc, there is some PowerPC assembler debugger in progress for MorphOS, but don't know, if it's still alive.

Bye, MarK.

PowerPC, for now I m just learning it. I read that barfly support PPC.
As Ralph is the author I though it was a good candidate under Morphos.

Kamel

well, the Barfly2.00 is from 1998, it probably helped in MorphOS beginnings, but it's obsolete now... I also programmed a simple 68k debugger in past, but it's not possible (?) to run these under MorphOS, as it doesn't allow to launch some supervisor instructions...

Bye, MarK.