I was gonna play some Mp3 just to test. But no sound is comming out of the internal speaker on my Quicksilver. Ive tried different settings in the Sound Pref but no go. Am i doing something wrong?

well, afair, mine (fw800) worked fine without any settings, so first check, if the speaker is well connected...

but according to mos team: audio is currently only supported for PowerMac3,4 to 3,6 models. isn't this your case?

bye, MarK.

[ Edited by MarK 04.08.2011 - 09:26 ]

Quicksilver 2002 is PowerMac 3,5, so should work.

[ Edited by Krashan 04.08.2011 - 08:52 ]

It works now. The weird part is that i had to plug a headset into the back of the machine before it worked. No it even playes without the headset..Weird computer

Another question about the internal speaker.
I bought a Quicksilver 800MHz 3.5 and are using a G15 keyboard, so i have no keys for tuning the volume.
Is there any possibility to adjust the volume of the startsound?
Is there something like a setup menu where i can adjust this at boot?
It's very loud by standard setting, therefore i did disconnect it, but without sound is little bit boring now.

Thanks for your help :)

AFAIK this can only be done from OSX side.

Boot into OSX (yeah I know that sucks) and turn the volume down there.

Should stay o.k aslong as you don't turn it up again in OSX.

(startupsoundprefs.pane seemed to be non-working on my QS)

Optimal solution:
Disconnect internal speaker, install SBlive ....

thnx for the help, have to install OSX first ;(