Can anyone help me?
I have just acquired an ATI radeon 7000 1.5v and when I was about to plug it I decided to have a look at the peg II manual and there I read that I had to check if the voltage was 3.3v Jesus Christ!!...Does it mean that I can burn the card, or the slot, or both, or the peg, or the house? Or am I just a bit too ignorant?

Hello smokumyslu,

I have read by ATI RADEON about the RADEON 7000

and the answer is: the card have a universal connector that working
with 1.5v and 3.3v thus the card working with the Pegasos!

I have the RADEON 8500 with the same connector and working good.

in the list FAQ "What graphics card works on the Pegasos?"
ATI Radeon 7000VE (RV 100), look to that number.

Greetings Cor van Londen.

thank you pegasosuser, I think you were right, but in the meantime I changed my Radeon 7000 for a 9200 which I'll try as soon as I get back home.

Quote:

That has been my understanding also. It will work either way. Have you tried it yet?

I have not that Card.

I have the information from ATI and MorphOS. (Morphzone FAQ)

Greetings Cor van Londen.

Yes, I have plugged it and it woks wonderfully. After your advice and
the information available in ATI page I feel a bit ashamed as it seems
too obvious that this type of cards with universal connectors are
intendet to be used in any type of slot. But, you know, when you.re
new to something or you are not sure of something it.s always better
to ask the people who know. Thanks both.