OK. SO I finally got my 825 based card in the mail. It has no 'BIOS' screen more typical of an adaptec card
1. Is there usually any way to setup e.g. auto termination?
2. It has an internal 68pin UW and external, is this a single 'through' bus?
3. It also has a 50pin connector..is this likely on the same bus as the 68, or it's own channel?
4. In MorphOS, should there be a device entry e.g. ncrscsi.device or somesuch?
5. I ran PCIscan and it says detected parity error...no idea if this is good or bad to be honest.

I will try to hook up a scsi drive and some terminators this evening so I may have more news then but if anyone can give a few clues to the above...that'd be great

Steve