Just identified another issue.

Computer boots fine and Morphos finds the graphics card (the x1900xtx) and also brings up a 1920 x 1080 24 bit display on boot.

However, when I do a soft reboot Morphos can’t find the monitor and instead boots an 8 bit 640 x 480 display. Then even a computer shutdown and turn back on doesn’t resolve this until I shut it down and then leave for a small period of time. After which it boots fine again.

I can go into Monitor preferences and reset the monitor settings each time but is there a way to avoid this? Is it possible to manually set the monitor rather than wait for Morphos to auto detect?