Yokemate of Keyboards
Posts: 2794 from 2006/3/21
From: Northern Calif...
Quote:
Zetec-s wrote:
Ok.
So the Graphics Card (a x1300Pro) and the Network card have turned up and I have installed them on PCIe slots 1 and 2 respectively, with the NVidia card on slot 3.
I've now booted into OpenFirmware and can see the screen using the NVidia card. I then got to run Morphos 3.14 install of a USB stick and all looks fine for a moment but it then freezes after the line;
DO-QUIESCE finished
I've tried moving the DVI cable over to the x1300pro but there is no output.
Any suggestions on what is wrong would be much appreciated.
Perhaps you should connect a 2nd monitor to the ATI video card during booting of MorphOS, so MorphOS will detect it and set up a screen mode to match the monitor? I've never tried a dual video card setup in any of my MorphOS systems, so I can't really tell you if this will work or not.
MorphOS - The best Next Gen Amiga choice.
