Quote:
bigfoot wrote:
Thanks for the log. And just to confirm, do you get a blank screen or does the firmware screen stick like earlier described by eightwonder?
Hello bigfoot
Here is my serial output (now it is a blank screen like Spectre)
U-Boot 2015.a (May 16 2015 - 14:17:51)
CPU: AMCC PowerPC 460EX Rev. B at 1150 MHz (PLB=230 OPB=115 EBC=115)
No Security/Kasumi support
Bootstrap Option H - Boot ROM Location I2C (Addr 0x52)
Internal PCI arbiter enabled
32 kB I-Cache 32 kB D-Cache
Board: Sam460ex/cr, PCIe 4x + PCIe 1x
I2C: ready
DRAM: 2 GiB (ECC not enabled, 460 MHz, CL4)
PCI: Bus Dev VenId DevId Class Int
00 04 1095 3114 0104 00
00 06 126f 0501 0380 00
PCIE0: successfully set as root-complex
02 00 1095 3132 0104 00
PCIE1: successfully set as root-complex
04 00 1002 6759 0300 ff
Net: ppc_4xx_eth0
FPGA: Revision 03 (2010-10-07)
SM502: found
PERMD2:not found
VGA: 1
VESA: OK
ABox 1.29 (26.6.2016) © 1999-2016 by Ralph Schmidt, Emmanuel Lesueur, Teemu Suikki, Harry Sintonen
Driver_InitBoard: Channels = 4 UnitsPerChannel = 1
PCI (S)ATA/ATAPI Driver@0: PIO Mode 4
PCI (S)ATA/ATAPI Driver@0: UDMA Mode 5
PCI (S)ATA/ATAPI Driver@1: PIO Mode 4
PCI (S)ATA/ATAPI Driver@1: UDMA Mode 5
sata.device@0: PIONEER DVD-RW DVR-221L <CDROM>
sata.device@0: CDRom <CD001>,<MORPHOS > found, bootable
sata.device@0: Mount <CD0>
sata.device@0: Partition <CD0> DosType 0x43444653 BootPri 127
sata.device@1: ATA-HD ST9160821AS <DIRECT_ACCESS>
Driver_InitBoard: Channels = 2 UnitsPerChannel = 1
SiI3132_Init:
SiI3132_Init: Taking port 0 out of reset
SiI3132_Init: Taking port 1 out of reset
SiI3132_Init: Port resets done
SiI3132_Init: Port 0 SStatus 00000000
SiI3132_Init: Port 0: Drive not present
SiI3132_Init: Port 1 SStatus 00000000
SiI3132_Init: Port 1: Drive not present
usbscsi.device@0: Mount <DH0>
usbscsi.device@0: Partition <DH0> DosType 0x444f5307
Radeon: Read BIOS ROM @0x16415054
