MorphOS Developer
Posts: 508 from 2003/4/11
For those of you benchmarking Quake 3, make sure you do the following:
1) Reboot
2) Don't run anything that uses OpenGL
3) Open a shell and type the following command: setenv TGLSYNC 0
4) Start Quake 3
5) In the Quake 3 console, type: r_primitives 2
6) In the same console, type: timedemo 1
7) Finally type: demo four
If you get anything below 50 FPS, you're either running a very high resolution on a very weak graphics card or you're using an Efika ;)
I rarely log in to MorphZone which means that I often miss private messages sent on here. If you wish to contact me, please email me at [username]@asgaard.morphos-team.net, where [username] is my username here on MorphZone.
