Hi can anybody please post there expirences of running MOS.1.4.5 with a Radeon 7000, i think there maybe a problem with my 7000 and the new radeon driver, any help would be apreciated.
Thanks

I use Radeon 7000 with 1.4.5 with no problem. Have you updated Mos or installed 1.4.5 alone?

can't even get that far, after Quark starts my screen goes blank and monitor goes into powersave, 1.4.3 worked fine tho???

Are you sure about the monitor configuration? I have an lcd hp and the HF - VF values declared were wrong but the Linux auto config shown me the correct values that I used in Mos and now all it's ok.
HP values (HF: 30-63, VF: 50-76) Bandwidth 76
Linux gives (HF: 28-50, VF: 43-75) Bandwith 75

I have the same problem here.
I can't install MorphOS 1.4.5..... plz. hlp...

The same problem is with other monitor !



The_Killer

Does this happen after you install MOS or when booting the CD?

Maybe you can boot the CD and edit the monitor value for CybergraphX in ENVARC to a lower value.

@Leon

The Problem is when i boot from the CD....



The_Killer

having done a manual install of 1.4.5 from a 1.4.3 cd, i have found that if you replace the radeon driver, with a different version it work's perfectly... looks to be a problem with the new radeon driver

Hi guys

fyi.. i installed 1.4.5 from cd perfectly and it runs nicely on my Radeon 7500..

magnetic

works here without probs.

Peg1, Radeon 7000, MOS 1.4.5